Analysis of transient temperature response under micro jet impinging using nitrogen (N2)

초록

We studied the transient local surface temperature response that occurs when jet impinging of nitrogen gas is applied to the surface to which a pulsating heat flux is applied. After manufacturing a micro jet impinging device, which was composed of three parts-a silicon wafer, a vinyl sticker, and a Pyrex wafer-nitrogen gas was used as working fluid and the velocity was 344.8 m/s, corresponding jet Reynolds was 1467. And the amplitudes of heat fluxes varied from 5.67 to 16.17 W/cm(2), the frequency also varied from 0.1 to 1000 Hz, then temperature response of RTDs was acquired. For example, when a heat flux, 8.5 W/cm(2), was applied with a frequency of 0.1 Hz, the highest and lowest temperatures of RTD located on the center of the heater and under indirect jets were 30.2 degrees C and 20.7 degrees C. From the acquired results, the time constant of the device was estimated between 17 ms and 32 ms, and this result shows the conjugated mode of conduction and convection of heat transfer. To understand the dominant heat transfer, we decoupled the conduction mode and the convective heat transfer mode through analytical calculations and confirmed that the time constants were 11 mu s and 128 ms, respectively. In addition, the heat transfer coefficient was inversely calculated through numerical calculation by simulating the RTD manufactured in the device, and through this, it was confirmed that the dimensionless time constant was related to the Nu number and the correlation was developed as tau/t = 3.51Nu(-1.067) for f <= 1 Hz.

키워드